Put the device into “test” mode by holding the on/off button down continuously (about 7-seconds) until the device vibrates. Now that the device is fully charged, unplug the device from the computer. Leave the device charging for 3 hours or until the light on the device turns off and the device is fully charged. After a few seconds, device turns itself on automatically. One vibration is felt as device turns off. If the device still does not turn on automatically, leave the device plugged in for at least 15 minutes and check to see if the device has turned on by viewing the green light on the device. If the device still does not turn on automatically, try using a different USB port or computer. If the device did not turn on automatically, please use a different cable and plug the device back into the computer. Please follow the steps below to test your Night Shift’s battery and vibration motors. Night Shift Battery and Vibration Test: Confirm Your Device Is Working A: When the strap is packaged, the retention bands are placed over the top of the magnetic ends of the strap.
0 Comments
Leave a Reply. |